UNPACKING AND CLEANING
Your
new scroll saw is
shipped
complete
in
one
carton. Carefully
unpack
the
saw
and all loose items. Fig. 2 Illustrates
the scroll saw and all loose items removed from the carton
Remove
the
protective
coating from the saw table surface.
This coating
may
be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline
or
lacquer thinner
for this purpose). After cleaning,
cover
the table
surface
with a
good
quality
paste wax.
WARNING: FOR
YOUR
OWN
SAFETY,
DO
NOT
CONNECT
THE
SCROLL
SAW
TO
THE
POWER
SOURCE
UNTIL
THE MACHINE IS
COMPLETELY
ASSEMBLED
AND
YOU
HAVE READ AND
UNDERSTAND
THE
ENTIRE
OWNERS
MANUAL.
A
A Scroll
Saw
B -
Quickset
Blade
Changing
Wrench
C - Allen
Wrench
o -
Holddown
Assembly
E
Table
Insert
Blank
Table
Insert
Not
Shown
Fig. 2
ASSEMBLY INSTRUCTIONS
1.
Loosen
lock
handle
(A) Fig. 3, and
move
table (B) to
the horizontal (level) position. Then tighten lock handle (A).
Fig. 3
2.
Slide holddown assembly bracket
(C)
Fig. 4, onto rod
(D) as shown, and tighten two screws located
underneath
bracket
(C)
using
wrench
(E) supplied.
Fig. 4
5
To Next Page
Loading...
