21
6
Press the button on the front operation panel for two seconds
to power on the UPS.
The UPS will be available for full runtime capability after the initial
five-hour charging
.
7
For optimal system protection, install the UPS monitoring software to fully
configure the UPS. Please download the software from
http://datacenter-softwarecenter.deltaww.com
1. The UPS (standard runtime model only) is equipped with internal
batteries and users can replace the batteries without shutting down
the UPS or connected loads (hot-swappable battery design). Battery
replacement is a safe procedure, isolated from electrical hazards.
2. Upon battery disconnection, equipment is not protected from power
outages.
Consider all warnings, cautions, and notes before replacing batteries.
1
Remove the battery cover.
2
Disconnect the battery cable.
To Next Page
Loading...
Need help?
General