Delta ASD-M-0721 Series User Manual

ASDA-M Chapter 8 Parameters
Revision December, 2014 8-137
Settings：
Manually adjust the hardware offset. The adjustment function
needs to be enabled by the setting of parameter P2-08. It is not
suggested to adjust the auxiliary adjustment. This parameter
cannot be reset.
P4-16 COF2
Current Detector (V2 Phase) Offset
Adjustment
Address: 0420H
0421H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16bit
Format：
DEC
Settings：
Manually adjust the hardware offset. The adjustment function
needs to be enabled by the setting of parameter P2-08. It is not
suggested to adjust the auxiliary adjustment. This parameter
cannot be reset.
P4-17 COF3
Current Detector (W1 Phase) Offset
Adjustment
Address: 0422H
0423H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16bit
Format：
DEC

Delta ASD-M-0721 Series Specifications

General

Brand	Delta
Model	ASD-M-0721 Series
Category	Servo Drives
Language	English