Delta ASD-M-0721 Series User Manual

Chapter 8 Parameters ASDA-M
8-138 Revision December, 2014
Settings：
Manually adjust the hardware offset. The adjustment function
needs to be enabled by the setting of parameter P2-08. It is not
suggested to adjust the auxiliary adjustment. This parameter
cannot be reset.
P4-18 COF4
Current Detector (W2 Phase) Offset
Adjustment
Address: 0424H
0425H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16bit
Format：
DEC
Settings：
Manually adjust the hardware offset. The adjustment function
needs to be enabled by the setting of parameter P2-08. It is not
suggested to adjust the auxiliary adjustment. This parameter
cannot be reset.
P4-19 TIGB
IGBT NTC Adjustment Detection Level
(cannot reset)
Address: 0426H
0427H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
1 ~ 4
Data Size：
16bit
Format：
DEC
Settings：
Please cool down the drive to 25 Celsius degree when adjusting

Delta ASD-M-0721 Series Specifications

General

Brand	Delta
Model	ASD-M-0721 Series
Category	Servo Drives
Language	English