Chapter 12 Descriptions of Parameter SettingsMS300
444
Setting 05: Conveyor
The following table lists the relevant conveyor setting application parameters.
Master frequency command source
(AUTO, REMOTE)
2 (External analog input)
Operation command source
(AUTO, REMOTE)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
Minimum output frequency of motor 1
Minimum output voltage of motor 1
Setting 06: Machine tool
The following table lists the relevant machine tool setting application parameters.
Master frequency command source
(AUTO, REMOTE)
2 (External analog input)
Operation command source
(AUTO, REMOTE)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
Minimum output frequency of motor 1
Minimum output voltage of motor 1
To Next Page
Loading...
Need help?
General
