Delta PCS100HV - Page 39

Installation Manual
32
Wiring Instructions
13: IGS_2
14: IGS_1
15: IGT_2
16: IGT_1
Auxiliary Power Interface Connector (CNS8)
The CNS8 connector is used for optional auxiliary power input with 24Vdc 0.5A.
When the grid side and battery side are both disconnected, the controller of PCS can be supplied by this
terminal.
When the grid side or battery side are connected, the controller of PCS will be supplied by internal
auxiliary power.
Connect two AWG 16 wires to the 2 pin connector as per the pin assignment table below.
Figure 27. CNS8 Pin Assignment
Table 9: Auxiliary Power Interface Connector
Item
Pin Assignment
Notes
CNS8
1: Vdc-1
24Vdc, 0.5A;
2: GND
DRM Connector (CNR7)
PCS100HV supports all the demand response modes (DRMs) defined in the standard AS/NZS 4777.2.
The CNR7 connector is an RJ45 socket that can be connected to a demand response enabling device
(DRED).
Pin 1