4
2 Installation and Wiring
2.1 Instruction before Installation
Due to the variety of users and installation environments, it is recommended to
read this manual thoroughly before installation. Installation of the unit and
start-up procedures must be carried out by accredited technicians.
2.2 Unpacking
Unpacking process is shown as Figure 2-1.
Figure 2-1: Unpacking process
Upon receiving your brand new RPI inverter, you will be required to remove its
protective packaging. This packaging consists of various materials that will
need to be disposed of according to the specific recycling marking printed on
them. Please note that cardboard may be recycled, whereas polystyrene foam
may not. Please dispose of the packaging materials in a correct manner to
ensure a better environment for us all.
To Next Page
Loading...
