19
ADJUSTING SLIDING FIT BETWEEN
TRUNNION AND BEVEL BRACKET
Af ter a long period of time it may become necessary to
adjust the sliding fit between the trunnion (A) Fig. 36, and
the bevel bracket (B) by tightening adjusting nut (C)
using a 3/4 socket wrench.
NOTE: This adjustment must be made with the bevel
lock handle (D) loose.
Correct adjustment is when a good snug sliding fit is
obt ained between these two p arts. This adjustment should
not be too tight that it restrict s the tilting movement of the
trunnion (A) when bevel cutting, or too loose that it af fects
the accuracy of the saw cut.
Fig. 36
D
C
A
B
To Next Page
Loading...
