TP70P-211LC1T/TP04P-20EXL1T Operation Manual
3-16
(7) After all calibrations are complete, the Undone changes to Done and Store Data [2] is shown in the lower right
corner, as the image shown below. Press
to save the settings. Otherwise, the changes will not be saved.
Use to go back to the main setting menu and you can see the status shown is Finish as the image shown
below. This indicates the calibration is complete.
You can reset all the settings to default. Use in the main setting menu to go back to defaults.
To Next Page
Loading...
Need help?
General
