Delta TS350 - Constructing a Push Stick

28 - English
When ripping work less than 6 inches wide, a push stick should be used to complete the feed and
could easily be made from scrap material by following the pattern shown in Fig. S25.
Fig. S25
PUSH STICK
MAKE FROM 1/2
"
OR 3/4
"
WOOD OR THICKNESS
LESS THAN WIDTH OF
MATERIAL TO BE CUT
CUT OFF HERE TO
PUSH 1/4
"
WOOD
CUT OFF HERE TO
PUSH 1/2
"
WOOD
NOTCH TO HELP
PREVENT HAND
FROM SLIPPING
1/2
"
SQUARES
CONSTRUCTING A PUSH STICK