To Next PageTo Next Page
Need help?Do you have a question about the Delta TS350 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 1.5 HP |
| Motor | Induction |
| Voltage | 120V |
| Amperage | 15 A |
| Max Rip Left | 12 inches |
| Max Rip Capacity | 30 inches |
| Arbor Size | 5/8 inches |
| Max Rip Right | 30 in |
| No-Load Speed | 4, 800 RPM |
| Bevel Capacity | 45 degrees |
| Max Depth of Cut at 90 degrees | 3.125 inches |
Explains safety symbols and terms used in the manual.
Detailed steps for removing and installing the saw blade.
Instructions for assembling and installing the blade guard and splitter.
Overview of controls, including starting, stopping, locking, and blade adjustments.
Adjusting blade angle stops for precise 90 and 45-degree cuts.
How to operate and align the rip fence for accurate cuts.
Using and adjusting the miter gauge for crosscuts.
A pre-operation checklist to ensure safety and proper setup.
Instructions for using the blade guard and splitter for safety.
Detailed procedure for performing cross-cutting operations.
Step-by-step guide for cutting boards lengthwise.
