10
Amplon N Series
No.
Multi-
function
Button
Description
2
The button has multi-function. Please refer to the following for de-
tailed information.
1. Turn-off:
z
z
In on-line mode, press and hold the button for 3 seconds,
release it after you hear one beep and the inverter will be off
and the UPS will transfer to run in standby/ bypass mode.
The UPS will keep charging the batteries when the UPS is
in standby/ bypass mode even though the button has been
pressed. To fully turn off the UPS, it is advised to unplug the
input power cord.
z
z
In battery mode, press and hold the button for 3 seconds, re-
lease it after you hear one beep and the UPS will turn off its
output.
2. Fault clear:
When the UPS has a fault condition, press and hold the button
for 3 seconds, release it after you hear one beep and the UPS
will clear the fault condition and return to standby/ bypass mode.
Besides, the LCD will show the relevant error code. For error
code information, please refer to 3.3 LCD Display - No. 9.
3. Scrolling down:
In setup mode, press the button for 0.1 second to go to the next
display.
3
The button has multi-function. Please refer to the following for de-
tailed information.
1. Scrolling down:
In non-setup mode, press the button for 0.1 second to go to the
next display.
2. Entering into the setup mode:
Press the button for 3 seconds and the UPS will enter into the
setup mode. For more information, please refer to 5.5 Setup
Mode. Please note that only qualied service personnel can per-
form setup action.
NOTE :
When the backlight of the LCD is off, you can press any button mentioned
above to wake up the display and enable each button function.
To Next Page
Loading...
Need help?
General