3. Delete the VeryFitPro app from your phone/tablet.
4. Open the Bluetooth settings on your phone/tablet and
delete/forget all devices listed (you can add these back later).
5. Reinstall the VeryFitPro app (don't open the app at this
point).
6. Plug your tracker into a USB socket away from other USB
devices that might cause interference. Make sure that the red
light is on and the charging symbol is displayed on the screen
to show that it's charging.
7. Open the VeryFitPro app and run through the set up. At the
point where the app starts searching for your tracker, hold your
phone/tablet close to your tracker and ensure that the
tracker’s display is turned on.
8. You should now be able to select ID115Plus HR (your
tracker) from the device list to complete the set up process.
STEPS
Why isn’t my step counter working correctly?
First you need to install the VeryFitPro app and run through
the set up process to pair it to your phone/tablet. Your tracker
will not function correctly if you skip this.
When you first set up your tracker it will go through an initial
calibration phase which can take up to a day to complete.
During this time you may find that steps may either not
register correctly or appear to jump around. This is
completely normal. After the first day of use, step counting
will register and record as expected.
It's also worth pointing out that after the calibration period,
the display will not always update in real time (step-by-step)
as you are walking. Under certain circumstances the screen
will update in batches of steps. This is especially apparent
when walking whilst watching the display.
14
To Next Page
Loading...