12
ENGLISH
• Input the distance between the listening position and the different speakers to set the delay time for the
surround mode.
Preparations:
Measure the distances between the listening position and the speakers
(L1 to L5) on the diagram at the right).
L1: Distance between center speaker and listening position
L2: Distance between front speakers and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speaker and listening position
L5: Distance between subwoofer and listening position
CAUTION:
Please note that the difference for every speaker should be 4.5 m or less.
NOTE:
• No setting when “None” has been selected for the Speaker Configuration setting.
Setting the delay time
Center FRFL
Subwoofer
SL
Listening position
SR
SB
1
Use the (left) and (right) buttons to set the distance from the front L
speaker to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is pressed.
Select the value closest to the measured distance.
Press the ENTER or (down) button to switch to the front R speaker setting.
2
Use the (left) and (right) buttons to set the distance from the front R
speaker to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is pressed.
Select the value closest to the measured distance.
Press the ENTER or (down) button to switch to the center speaker setting.
3
Use the (left) and (right) buttons to set the distance from the center
speaker to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is pressed.
Select the value closest to the measured distance.
Press the ENTER or (down) button to switch to the surround L speakers
setting.
5
Use the (left) and (right) buttons to select your subwoofer setting.
(Initial)
(left) button (right) button
Press the ENTER or (down) button to enter the settings and switch to the
Speaker Distance setting.
• Parameters
Large .........Select this when using speakers that have sufficient performance for reproducing bass sound
below the frequency set for the Crossover Frequency mode.
Small..........Select this when using speakers that do not have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode. When this is set, bass sound
with a frequency below the frequency set for the Crossover Frequency mode is sent to the
subwoofer.
None..........Select this when no speakers are installed.
Yes/No .......Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
“Small” is set for the front, center and surround speakers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
