Denon AVR-2312

17
1. µcom/DSP Version display mode
1.1. Operationspecications
µcom/DSP version display mode:
When the set is started up in this mode, the version information is displayed.
Starting up:
Press the "ON/STANDBY" button to turn on the power while pressing the "STATUS" and "iPod
1
" buttons.
Now, press the "STATUS" button to the display the 2nd item information on the FL Display.
b
When the version is displayed on the FL Display, the version list is also displayed on the OSD.
1.2. Display Order
Error information(Refer to 1.3. Error display) →
q
Model destination information →
w
Firmware Package Version
→
e
Main µ-com/MAIN FBL(1st Boot Loader) Version →
r
Sub µ-com/Sub FBL →
t
DSP version →
y
Audio PLD →
u
GUI SFLASH
→
i
Ethernet(DM860) 1st Boot Loader, Hardware ID →
o
Ethernet(DM860) 2nd Boot Loader, Rhapsody Flag
→
Q0
Ethernet(DM860) IMAGE →
Q1
Ethernet(DM860)MAC ADDRESS information
→
Q2
MultEQ Pro APP(Displayed when Audyssey Pro is complete)
→
Q3
MultEQ Pro ICL(Displayed when Audyssey Pro is complete
q
Model destination information :
Upper
A V R 2 3 1 2 E 3 : * * * *
Lower
S / N . * * * * * * * * * *
w
Firmware Package Version :
Upper
F i r m . P a c k a g e
Lower
V e r . : * * * *
e
Main µ-com & MAIN FBL version :
Upper
M a i n : * * . * *
Lower
M a i n F B L : * * . * *
r
Sub µ-com & Sub FBL :
Upper
S u b : * * . * *
Lower
S u b F B L : * * . * *
t
DSP ROM :
Upper
D S P : * * . * *
Lower
y
Audio PLD :
Upper
A u d i o P L D : * * . * *
Lower
u
GUI SFLASH :
Upper
G U I : * * * * * * * *
Lower