Denon AVR-3805 - Page 46

46
4
Enter the setting.
The Option Setup Menu reappears.
3
Select the desired setting.
Variable:
The level can be adjusted freely using the buttons on
the remote control unit.
0 dB, -40 dB:
The output level is fixed at the set level and the
volume can no longer be adjusted.
NOTE:
• When “ZONE2” is selected at System Setup Menu
“5-1.Power amp Assign”, the Zone2 vol. Level is all
set to “variable” including preout level and this
menu is not displayed.
Variable
*Zone2 Vol.Lev.
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
5-3, 5-4
Setting the Trigger Out Setup
• Set the Trigger Out output 1 for the different input sources.
1
2
3
Select “Trigger Out 1 Setup” at the Option Setup
Menu.
Display to the Trigger Out 1 Setup screen.
Select the Zone (MAIN, Zone2 and Zone3).
Trigger Out 1
*Option Setup
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
ZONE : MAIN
*Trigger Out 1
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
4
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
5
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
Enter the setting
The Option Setup Menu reappears.
Set the Trigger out 2 Setup in the same way.
w Select “ON” or “OFF”.q Select the input source.