• Operating the surround mode and surround parameters from the main unit's panel.
1
Turn the SELECT knob to select the surround mode. _
..... t O[:::
o
Z
o
(Mainunit)
• When turned clockwise
1 2 1,3
• When turned counterclockwise
-_ TOselect the surround mode while adjusting the surround parameters, channel volume or tone control, press the surround mode button
then operate the selector.
SURROUND
MODE
2
(Malnunit)
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
• The parameters which can be set differ for the different surround modes. (Refer to "Surround Modes and Parameters" on page 52.)
SURROUND
pARAMETER
(Maln unit)
Display the parameter you want to adjust, then turn the SELECT knob to set it.
NOTE:
• When playing PCM digital signals or analog signals in the DOLBY PRO LOGIC, DTS NEO:6 modes and the input signal switches to a digital
signal encoded in Dolby Digital, the Dolby surround mode switches automatically. When the input signal switches to a DTS signal, the mode
automatically switches to DTS surround.
• When the "5CH/6CH STEREO" mode is selected, the display differs according to the SB CH OUT setting.
Surround Back CH ON : 6CH STEREO
Surround Back CH OFF : 5CH STEREO
To Next Page
Loading...
Need help?
General
