25
3
Enter the setting.
The System Setup Menu reappears.
[1] Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at “SURR. BACK/ZONE2 PREOUT” terminals.
1
At the System Setup Menu select “Zone2 Control”
and press the ENTER button.
Setting the ZONE2 Control
2
The “Zone2 Control” screen appears.
Select “Power Amp Assignment” and press the
ENTER button.
3
Select “Surround Back” to use as the surround back
channel, “Zone2” to use as Zone 2 out.
When “Surround Back” is selected When “Zone2” is selected
4
Enter the setting.
At the “Zone2 Control” screen, select “Exit” and press the ENTER button.
The System Setup Menu reappears.
[2] Setting the Zone2 vol. level
Set the Zone 2 pre-out output level adjustment.
1
At the System Setup Menu select “Zone2 Control”
and press the ENTER button.
To Next Page
Loading...
Need help?
General
