41
9
OPERATION
Before operating
1
Refer to “CONNECTIONS” (pages 6 to 13) and check that all
connections are correct.
2
Select “AMP mode” using the TAPE, CDR/MR or CD
button. (only when operating with the remote control unit)
3
Turn on the power.
Press the POWER switch (button).
(Main unit) (Remote control unit)
Light
When pressed, the power turns on and the display lights. The sound
is muted for several seconds, after which the unit operates normally.
When pressed again, the power turns off, the standby mode is set
and the display turns off.
Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected on AC line voltage. Please be sure to
unplug the cord when you leave home for, say, a vacation.
(Remote control unit)
4
The front speakers switch as shown below each time the
FRONT SPEAKER button is pressed.
(Main unit) (Remote control unit)
To Next Page
Loading...
