38
(3) Using the system call function
1
Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
Punch Through
(1) Punch through button
Buttons used in the CD, CDR/MD, TAPE, DVD/VDP, and VCR
modes can be assigned to the buttons shown on the diagram at
the right which are not normally used in the TV and DBS/CABLE
modes.
For example, when the CD mode is set to the punch through mode
in the TV mode, the CD mode’s PLAY, STOP, MANUAL SEARCH,
AUTO SEARCH, PAUSE and DISC SKIP buttons’ signals are sent
in the TV mode.
(2) Making the punch through setting
1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
•
The LEARNED/TX indicator flashes.
Press the 1 (play) button.
•
TV and DBS/CABLE mode buttons and LEARNED/TX
indicator flash.
3
Press the mode button of the equipment for which Punch
Through is to be set.
• The CD, CDR/MD, TAPE, DVD/VDP, and VCR mode buttons
and LEARNED/TX indicator will flash.
4
Press the mode button of the equipment that is to be
punched through.
• The mode button that was set will light.
To Next Page
Loading...
Need help?
General
