1
Press the USE/LEARN button with the tip of a pen, etc., to set
the learn mode.
• The mode selector buttons and LEARNED/TX indicator
flash.
Flashes
2
Press the mode button of the equipment that is to be reset.
• Mode button and LEARNED/TX indicator flash.
3
Hold for 4 seconds or longer the mode button of the
equipment that is to be reset and the ON/SOURCE button.
• The mode button and the LEARNED/TX indicator will again
flash, and the learned remote control signal of the selected
equipment will be deleted.
4
Press the USE/LEARN button.
To Next Page
Loading...
