ZONE2 Setup
Configure the settings for audio playback on ZONE2.
Values set for “Volume Limit” and “Power On Volume” are displayed according to the
setting specified for the volume “Scale” (v p. 142).
o
Lch Level
Adjust the left channel output level.
-12 dB – +12 dB (Default : 0 dB)
o
Rch Level
Adjust the right channel output level.
-12 dB – +12 dB (Default : 0 dB)
o
Volume Level
Set the volume output level.
Variable
(Default):
Volume can be adjusted.
1 – 98
(–79.5 dB – 18.0 dB):
Volume is fixed at the desired level. The
volume cannot be adjusting using the remote
control unit.
o
Volume Limit
Make a setting for maximum volume.
60 (-20 dB) / 70 (-10 dB) / 80 (0 dB)
(Default : 70 (-10 dB))
Off: Do not set a maximum volume.
This can be set when “Volume Level” is set to “Variable”. (v p. 190)
o
Power On Volume
Define the volume setting that is active when the power is turned on.
Last
(Default):
Use the memorized setting from the last
session.
Mute: Always use the muting on condition.
1 – 98
(–79.5 dB – 18.0 dB):
The volume is adjusted to the set level.
This can be set when “Volume Level” is set to “Variable”. (v p. 190)
Contents Connections Playback Settings Tips Appendix
190
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
