Denon AVR-X2100W User Manual

o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. 142
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
－
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors.
39
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
150
0
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV. 118
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected.
28
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. 174
0
Check the “Assign Mode” setting in the menu. 173
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and
subwoofer.
－
No sound is produced from
subwoofer.
0
Check the subwoofer connections.
29
0
Turn on the subwoofer’s power. －
0
Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
174
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
174
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
179
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. 179
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”. －
0
Set “Decode Mode” on the menu to “Auto” or “DTS”.
162
Dolby TrueHD, DTS-HD,
Dolby Digital Plus audio is
not output.
0
Make HDMI connections. 44
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by
default.
－
Contents Connections Playback Settings Tips Appendix
206
Front panel Display Rear panel Remote Index

Denon AVR-X2100W Specifications

General

Receiver type	Surround
Frequency range	10 - 100000 Hz
Audio output channels	7.1 channels
Signal-to-Noise Ratio (SNR)	100 dB
Power output per channel (1KHz@6 Ohm)	150 W
Power output per channel (20-20KHz@8 Ohm)	95 W
HDMI in	8
Composite video in	2
Component video (YPbPr/YCbCr) in	1
Speakers connectivity type	-
Ethernet LAN	Yes
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Optical drive included	No
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD
Apple docking compatibility	iPhone, iPod
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	500 W

Weight and Dimensions

Depth	339 mm
Width	434 mm
Height	167 mm
Weight	9700 g