Denon AVR-X7200W

5. Additional Source mode
s
5.1. Actions
• The Additional Source setting is added for the custom installer. When the setting is "ON", AUX3-7 is added as a Source.
It is possible to add the number of Sources for use by assigning various input connectors in Input Assign Menu.
• The added AUX3-7 is displayed and available for selection in the Source related settings such as Input Setup in Setup
Menu.
• The default setting is "OFF".
5.2. Starting up
Hold down buttons "SLEEP" and "A-DSX" at the same time and press the power button to turn on the power.
5.3. Operations
1. After the POWER ON sequence, FLD displays the indication for the Additional Source mode.
2. Press the "CURSOR
0/1
" buttons to select the setting.
ON
OFF
FLD
L1
* A d d S o u r c e M o d e
L2
< O F F >
• ON is selected
FLD L2
< O N >
• OFF is selected
FLD L2
< O F F >
3. Press the "ENTER" button to conrm the setting.
6. Protection Pass Mode
6.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
6.2. Operations
Hold down buttons "
CURSOR
0
", "STATUS" and "ZONE3 SOURCE" at the same time and press the power button to turn
on the power.
The device returns to the normal display after the following is displayed.
FLD L1
P r o t e c t i o n P a s s
This is displayed for 5 seconds before returning to the normal display.
76