EasyManuals Logo
Home>Denon>Receiver>AVR-X7200W

Denon AVR-X7200W Service Manual

Denon AVR-X7200W
278 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
Error
Code
DPMS Update Error Display Details of Error code Coping strategies
5B
S u b * * * m i n
U p d a t i n g f a i l 5 B
NACKreceivedinresponseorno
responsefromSubforLcom-
mand.
Turnonthepoweragain.Updatewill
startautomatically.
5C
S u b * * * m i n
U p d a t i n g f a i l 5 C
NoUpdatePacketreceivedfrom
CX870/CY920(TimeOut).
Turnonthepoweragain.Updatewill
startautomatically.
5D
S u b * * * m i n
U p d a t i n g f a i l 5 D
AbnormaldatainUpdatePacket
receivedfromCX870/CY920
(CRCError).
Turnonthepoweragain.Updatewill
startautomatically.
5E
S u b * * * m i n
U p d a t i n g f a i l 5 E
AbnormaldatainUpdatePacket
receivedfromCX870/CY920
(PacketNoError).
Turnonthepoweragain.Updatewill
startautomatically.
5F
S u b * * * m i n
U p d a t i n g f a i l 5 F
Setupfailureofthetransfer
methodofXModem.
Turnonthepoweragain.Updatewill
startautomatically.
60
S u b * * * m i n
U p d a t i n g f a i l 6 0
NACKreceivedinresponseorno
responsefromSubfor"P"com-
mand.
Turnonthepoweragain.Updatewill
startautomatically.
61
S u b * * * m i n
U p d a t e C h e c k N G 6 1
MismatchedCheckSuminre-
sponseornoresponsefromSub
for"I"command.
Turnonthepoweragain.Updatewill
startautomatically.
62
S u b * * * m i n
U p d a t i n g f a i l 6 2
FailedtostartupSubinPowerOn
sequenceduringUpdate.
Turnonthepoweragain.Updatewill
startautomatically.
80
G U I * * * m i n
U p d a t i n g f a i l 8 0
WriteEnableLatchBitnotsetin
ReadafterissuingWRENcom-
mand.
Turnonthepoweragain.Updatewill
startautomatically.
81
G U I * * * m i n
U p d a t i n g f a i l 8 1
BlockErasefailedinReadafter
issuingBEcommand.
Turnonthepoweragain.Updatewill
startautomatically.
82
G U I * * * m i n
U p d a t i n g f a i l 8 2
NoUpdatePacketreceivedfrom
CX870/CY920(TimeOut).
Turnonthepoweragain.Updatewill
startautomatically.
83
G U I * * * m i n
U p d a t i n g f a i l 8 3
AbnormaldatainUpdatePacket
receivedfromCX870/CY920
(CRCError).
Turnonthepoweragain.Updatewill
startautomatically.
84
G U I * * * m i n
U p d a t i n g f a i l 8 4
AbnormaldatainUpdatePacket
receivedfromCX870/CY920
(PacketNoError).
Turnonthepoweragain.Updatewill
startautomatically.
85
G U I * * * m i n
U p d a t i n g f a i l 8 5
Setupfailureofthetransfer
methodofXModem.
Turnonthepoweragain.Updatewill
startautomatically.
86
G U I * * * m i n
U p d a t i n g f a i l 8 6
MismatchedCheckSuminCheck
Sumcomparisonafterrewriting.
Turnonthepoweragain.Updatewill
startautomatically.
A0
E t h e r I M G * * * m i n
C o n n e c t i o n F a i l A 0
IPAddressacquisitionfailure
(AutoIP).
Checkthenetworkconnection.Update
inanenvironmentwherethereisa
smallnetworkload.
94

Table of Contents

Other manuals for Denon AVR-X7200W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X7200W and is the answer not in the manual?

Denon AVR-X7200W Specifications

General IconGeneral
Receiver typeSurround
Input sensitivity200 mV
Audio output channels11.2 channels
Signal-to-Noise Ratio (SNR)102 dB
Power output per channel (1KHz@6 Ohm)190 W
Power output per channel (20-20KHz@8 Ohm)210 W
HDMI in8
Audio (L/R) in7
Composite video in5
Digital audio optical in2
Ethernet LAN (RJ-45) ports1
Component video (YPbPr/YCbCr) in3
12V triggerYes
Speakers connectivity type-
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Optical drive includedNo
DisplayLCD
Product colorBlack
Audio decodersDolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)780 W
Weight and Dimensions IconWeight and Dimensions
Depth427 mm
Width434 mm
Height196 mm
Weight17800 g

Related product manuals