o
Decode Mode
Set the audio decode mode for input source.
It is normally recommended to set the audio input mode to “Auto”. But
we recommend changing it to “PCM” or “DTS” if the start of the source
is clipped or noise occurs.
Auto
(Default):
Detect type of digital audio input signal
and decode and play automatically.
PCM: Decode and play only PCM input signals.
DTS: Decode and play only DTS input signals.
This item can be set for input sources for which “HDMI” or “DIGITAL” is assigned
at “Input Assign” (v p. 219).
Upgrade (Auro-3D)
Auro-3D:
The input signal is decoded using an
Auro-3D decoder.
0
This item can always be set on models supporting Auro-3D.
0
The sound modes you can select are Auro-3D or Auro-2D Surround when the
“Decode Mode” setting is “Auro-3D”.
Contents Connections Playback Settings Tips Appendix
223
Front panel Display Rear panel Remote Index
To Next Page
Loading...
