Listening to music on an iPod
1
Connect the iPod to the USB port. (v p. 76)
2
Press iPod/USB to switch the input source to “iPod/
USB”.
0
Select the USB port to be used. (v p. 92)
The USB port on the front panel can be used by default.
0
“Browse from iPod” is displayed on the display of this unit.
0
Nothing is displayed on the TV screen.
3
Operate iPod itself while seeing the iPod screen to play
back music.
0
“iPod Browse Mode” has two modes, “From iPod” and “On-Screen”. By default,
“From iPod”, where you operate the iPod itself while looking at the iPod screen, is
set.
0
To change to “On-Screen”, where you perform operations while having the iPod
information displayed on the TV screen, see “iPod Browse Mode settings”
(v p. 91).
NOTE
0
Depending on the type of iPod and the software version, some functions may not
operate.
0
Note that Denon will accept no responsibility whatsoever for any problems arising
with the data on an iPod when using this unit in conjunction with the iPod.
o
Operations accessible through the option
menu
This can be operated when the “iPod Browse Mode” (v p. 91) is
set to “From iPod”.
0
“Setting the USB port to use (USB Select)” (v
p. 92)
0
“iPod Browse Mode settings” (v p. 91)
0
“Adjusting the audibility of dialog and vocals (Dialog
Enhancer)” (v
p. 144)
0
“Adjusting the volume of each channel to match the input source
(Channel Level Adjust)” (v
p. 145)
0
“Adjusting the tone (Tone)” (v p. 146)
0
“Displaying your desired video during audio playback (Video
Select)” (v
p. 147)
0
“Adjusting the picture quality for your viewing environment (Picture
Mode)” (v p. 148)
0
“Playing the same music in all zones (All Zone Stereo)” (v
p. 149)
Contents
Connections Playback Settings Tips Appendix
90
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
