o
Operations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be
performed through the
remote control unit.
0
Batteries are worn out. Replace with new batteries. 11
0
Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an angle of within
30°.
11
0
Remove any obstacle between this unit and the remote control unit. －
0
Insert the batteries in the proper direction, checking the q and w marks.
11
0
The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb
light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light.
－
0
The operation target zone does not correspond to the zone setting specified on the remote control unit.
Press ZONE SELECT to select the zone to operate.
186
0
The remote control unit operating mode is used to operate other devices. Press AVR to set the operating
mode to AVR.
294
0
When using a 3D video device, the remote control unit of this unit may not function due to effects of
infrared communications between units (such as TV and glasses for 3D viewing). In this case, adjust the
direction of units with the 3D communications function and their distance to ensure they do not affect
operations from the remote control unit of this unit.
－
o
Display on this unit shows nothing
Symptom Cause / Solution Page
Display is off.
0
Set “Dimmer” on the menu to something other than “Off”. 283
0
When the sound mode is set to “Pure Direct”, the display is off. 152
Contents Connections Playback Settings Tips Appendix
312
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
