8
Move the Sound calibration microphone to position 2,
select “Continue”, then press ENTER.
The measurement of the second position starts.
Measurements can be made in up to eight positions.
.
Complete
Continue
Place the microphone ear level at the 2nd listening position,
which should be no more than 2 ft (60cm) away from the 1st
position, then select “Continue”...
Back
Ear Height
Audyssey Setup
To skip measuring the second and subsequent listening position, press o to
select “Complete” and press ENTER to proceed to step 11.
n
Stopping Audyssey
®
Setup
A
Press BACK to display the popup screen.
B
Press o to select “Yes”, then press ENTER.
9
Repeat step 8, measuring positions 3 to 8.
10
Select “Continue”, then press ENTER.
.
Audyssey Setup
Continue
Repeat Last Test
Measurements complete.
Select Continue to analyze the data...
Start the analysis and storage of the measurement results.
0
Analysis takes several minutes to complete.
The more speakers and measurement positions that there are,
the more time it takes to perform the analysis.
NOTE
When the measurement results are being saved, make sure the power is not
turned off.
Contents Connections Playback Settings Tips Appendix
229
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
