o
WPS Router
Use a WPS-compatible router to connect.
There are two ways to connect, using the push button method or the
PIN code method. Select the connection method to match your router.
n
When connecting using the push button method
1. Select “Push Button” on the TV screen.
2. Switch to the WPS mode by pressing the WPS button of the
router you wish to connect to.
0
The time for pressing the button varies depending on the
router.
3. Select “Connect” on the TV screen within 2 minutes.
n
When connecting using the PIN code method
1. Select “PIN” on the TV screen.
2. Register the PIN code of the unit in the router.
o
Manual
Enter the name (SSID) and password of the network you wish to
connect to.
1. Set the following items.
SSID: Input the name of the wireless network (SSID).
Security:
Select the encryption method according to the
encryption setting of the access point you are using.
Password: Input the password.
Default Key:
Select the Default Key.
When connecting to a “WEP” encrypted network,
“Default Key” menu is displayed.
2. Select “Connect” at the end of the setting.
The wireless LAN (Wi-Fi) settings of this unit can also be configured from a PC or
tablet that supports wireless LAN connection.
When using a device that has a firmware version of iOS7 or later, “When connecting
using Wi-Fi” (v p. 272) in “Use iOS Device”.
1. Press and hold the DIMMER and STATUS buttons on the main unit for at least 3
seconds when the power of the unit is on.
2. Connect the wireless LAN of the PC or tablet used to “Denon AVR-X7200W” when
the message “Connect your Wi-Fi device to Wi-Fi network called “Denon AVR-
X7200W”” appears in the display.
3. Start up the browser and enter “192.168.1.16” in the URL.
4. Use the browser to enter the settings, select “Connect” and then exit the settings.
Contents Connections Playback Settings Tips Appendix
273
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
