Denon AVR-X7200W User Manual

Setting the back light
You can set the back light on the remote control unit to off to prolong the
life of the dry cell batteries.
0
The default setting is “ON”.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “LIGHT” on the remote control unit
and press ENTER.
3
Use ui to set the back light and press ENTER.
Remote control unit display Back light
ON Back light on
OFF Back light off
Restoring all settings of the remote
control unit to default
All the settings are restored to their defaults.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “RESET” on the remote control unit
and press ENTER.
3
Use ui to display “ALL” on the remote control unit
and press ENTER.
4
Use ui to display “YES” on the remote control unit
and press ENTER.
“RESET” flashes four times on the remote control unit and the
normal operation mode is restored.
Contents Connections Playback Settings Tips Appendix
306
Front panel Display Rear panel Remote Index

Denon AVR-X7200W Specifications

General

Receiver type	Surround
Input sensitivity	200 mV
Audio output channels	11.2 channels
Signal-to-Noise Ratio (SNR)	102 dB
Power output per channel (1KHz@6 Ohm)	190 W
Power output per channel (20-20KHz@8 Ohm)	210 W
HDMI in	8
Audio (L/R) in	7
Composite video in	5
Digital audio optical in	2
Ethernet LAN (RJ-45) ports	1
Component video (YPbPr/YCbCr) in	3
12V trigger	Yes
Speakers connectivity type	-
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Optical drive included	No
Display	LCD
Product color	Black
Audio decoders	Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	780 W

Weight and Dimensions

Depth	427 mm
Width	434 mm
Height	196 mm
Weight	17800 g