11
DCD-710AE
SPECIAL MODE
No Key name Function Display
1
Service mode
• POWER switch is turned to on while pressing the
5 and 2 button same time on DCD-
710AE.(Model name display)
1.1
Version No. of
main μ-com
Display mode
• Press the 9 button.
"****" : Version number of main μ-com
1.2
Version No. of
USB μ-com
Display mode
• Press the 9 button while version No. of main
μ-com is displayed.
"****" : Version number of USB μ-com
1.3 FLD check mode
• When display is version No. of USB μ-com and
the 9 button is pressed, turn on the entire dis-
play is flashing with an interval of about 1 second.
• Press the 9 button again in the turn on each
grid of FLD. (Each grid is displayed at interval of 1
second.)
1.4
Input button
name Display
mode
• When display is each grid of the FLD check mode
and the 9 button is pressed, display name of
the pressing button.
• Turn off the POWER switch to clear this mode.
2 CD test mode
• POWER switch is turned to on while pressing the
5 and 2 button same time on DCD-
710AE.(Entering the Service mode)
• Press the
/
13 and 2 button same time while
service mode.(CD TEST MODE display)
13 flashing
2.1 Disc loading
• Press the 5 button to open the tray.
• Set a disc on the tray, then press the 5 button
again to close the tray.
2.2 Servo check
• Press the
/
13 button. Execute the following
steps.
q LD ON (with servo still stopped)
w FOCUS ON (disc rotation, tracking off)
If no disc loaded, retry then stop.
e CLV ON
・13 flashing
q
w
e
To Next Page
