14
DCD-710AE
2.7
Adjustment value
display
u RFRP
i Return to q.
(Note)If auto adjustment is not completed, proper
values are not displayed.
u
XX : Adjustment value
2.8
Accumulated
laser on time
display
・When the DISC/USB and 5 button is pressed
while the DCD-710AE is in the stop mode, the
accumulated laser on time is displayed.
・The laser drive times are added and the result is
displayed.
・One count corresponds to 10 minutes. (Values
under 10 minutes are discarded.)
・Count values are stored in the EEPROM every 10
minutes.
・The accumulated laser on time is displayed in
hours.
・Laser ON/OFF is monitored and counted.
・Press the 2 button, CD test mode display (2)
reappears.
・The count values are not cleared, even when the
set is reset.
・Minimum display specification
• No. digits stored in EPROM: 4, 0xFFFF
• No. digits displayed: 5
• When the time exceeds 10922 hours, the
stored data is not updated and the value is
fixed to 0xFFFF.
(The display is fixed to 10922 hours.)
q Count value is reset
・When the
/
13 button is pressed for over 5
seconds while the accumulated laser on time is
displayed, the count value is reset.
・After resetting is completed, the display in 2.8
(00000 hours on the top line) reappears, and
after 5 seconds the model name display
reappears.
・Count value is reset upon shipment from the
factory and when the mechanism is replaced.
・13 flashing
q
3
CD heat run
mode
・AC is turned on while pressing the 5 and 2 button
same time on Main Unit.
・Switches to mode according to button input.
・Press a reverse button to switch the mode while
displaying the version of the main μcom.
(Normal heat run mode, Heat run short mode,
Automatic mounting mode.)
・If an error occurs, display the error and stop
operation at that point.
・Number of operations held.
・While heat run, the operation of each button is not
valid except the ON/STANDBY button and
pressing the 5 and 2 button same time.
No
Key name
Function Display
To Next Page
Loading...
