Denon DN-D4500 - Page 22

22
DN-D4500
PCM1748 (IC503,553)
64M SDRAM (IC110,210)
128M SDRAM (IC402)
BU2090F (IC702,802) TPC6103 (IC410)
BCK
DATA
LRCK
DGND
V
DD
V
CC
V
OUT
L
V
OUT
R
SCK
ML
MC
MD
ZEROL/NA
ZEROR/ZEROA
V
COM
AGND
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
PCM1748
Serial
Input
I/F
Output Amp and
Low-Pass Filter
DAC
8x
Oversampling
Digital Filter
with
Function
Controller
Enhanced
Multi-Level
Delta-Sigma
Modulator
Output Amp and
Low-Pass Filter
DAC
BCK
LRCK
DATA
ML
MC
MD
Function
Control
I/F
System Clock
Manager
Zero Detect
Power Supply
V
OUT
L
V
COM
V
OUT
R
V
DD
DGND
ZEROL
ZEROR
SCK
System Clock
V
CC
AGND
Pin Assignment
DescriptionPin No. Pin Name Function
22, 23~26, A0~A11 Address Multiplexed pins for row and column address.
29~35 Row address: A0~A11. Column address: A0~A8.
20, 21 BS0, Bank Select Select bank to activate during row address latch time, or bank to
BS1 read/write during address latch time.
2, 4, 5, 7, 8, DQ0~ Data Input/Output Multiplexed pins for data output and input.
10,11, 13, 42, DQ15
44,45, 47, 48,
50, 51, 53
19 CS# Chip Select Disable or enable the command decoder. When command decoder is
disabled, new command is ignored and previous operation continues.
18 RAS# Row Address Strobe Command input. When sampled at the rising edge of the clock,
RAS#, CAS# and WE# define the operation to be executed.
17 CAS# Column Address Strobe Referred to RAS#
16 WE# Write Enable Referred to RAS#
15, 39 UDQM/ input/output mask The output buffer is placed at Hi-A (with latency of 2) when DQM is
LDQM sampled high in read cycle. In write cycle, sampling DQM high will
block the write operation with zero latency.
38 CLK Clock Inputs System clock used to sample inputs on the rising edge of clock.
37 CKE Clock Enable CKE controls the clock activation and deactivation. When CKE is low,
Power Down mode, Suspend mode, or Self Refresh mode is entered.
1, 14, 27 Vcc Power (+3.3V) Power for input buffers and logic circuit inside DRAM.
28, 41, 54 Vss Ground Ground for input buffers and logic circuit inside DRAM.
3, 9, 43, 49 VccQ Power (+3.3V) for I/O buffer Separated power from Vcc, used for output buffers to improve noise.
6, 12, 46, 52 VssQ Ground for I/O buffer Separated ground from Vss, used for output buffers to improve noise.
36, 40 NC No Connection No Connection
154
27 28
TOP VIEW
654
123
16 VDD1Vss
15 Q112DATA
14 Q103CLOCK
13 Q94Q0
12 Q85Q1
11 Q76Q2
10 Q6
Q5
7Q3
9
8Q4
Control Circuit
12-Bit Shift Register
Latch
Output Buffer
(Open Drain)