14
4. Adjusting mode of the touch sense sensitivity
The unit can control the sensitivity of the touch sensor for the Jog Wheel in 9 steps (-4 to 0 to +4).
“-4” is the lowest sensitivity, and “+4” is the highest sensitivity.
The default setting is “0”.
(1) Pressing (SHIFT+LOAD A+LOAD B) at the same time, then connect MC2000 to a PC.
(2) Press CUE, and switch the jog wheel that you want to adjust.
(e.g.) If you press CUE of the left side, only CUE of the left side turns on, and jog wheel of the left deck is chosen to
adjust it.
(3) Rotate the track selection knob, and adjust the sensitivity. The button lights according to the set sensitivity.
Adjust level -4 -3 -2 -1 0 1 2 3 4
Buttons HOT CUE 1 HOT CUE 2 HOT CUE 3 LOOP IN LOOP OUT AUTO FX1/2-1 FX1/2-2 FX1/2-3
(4) Press the track selection knob to memorize adjustment data.
(5) Press SHIFT, then the mode switches back from the sensitivity adjustment mode to the normal mode.
5. Initialization of parameters
Return to factory default setting.
(1) Pressing (SHIFT+BACK+FWD+LOAD B) at the same time, then connect MC2000 to a PC .
(2) Return to default setting, and these data (as follows) turn to factory default setting.
Upon completion of the adjustment, it automatically restarts, start in Normal mode.
Initialize Data Factory default Range
JW transmission interval time 4ms 3ms
⇔
20ms
Sensitivity of JOG Wheel 0 -4
⇔
4
2 3 4
-1 0
-3 -2
1
-4
2 3 4
-1 0
-3 -2
1
-4
Left deck Right deck
To Next Page
Loading...
Need help?
General
