Denon MC2000 Service Manual

15
6. Adjusting interval time of MIDI command transmission
Setting the MIDI command transmission interval time.
Depending on the computer specications and OS type, the computer may not be able to receive the MIDI commands
transmitted from this unit correctly.
In this case, use the following operation to set the MIDI command transmission interval time to a suitable value.
(1) Pressing (SHIFT+BROWSE1 +BROWSE2) at the same time, then connect MC2000 to a PC .
The following LED turns on, and the unit switches to the setting mode for MIDI command transmission interval time.
(2) Rotate SEL..
The relationship between LED display position and the MIDI command transmission interval time is as shown in the
diagram as follows. The factory setting is 4 msec.
(3) Press SEL..
The MIDI command transmission interval time is entered.
(4) Press SHIFT.
The settings are completed, and unit exits the setting mode.
How to read the interval time
Interval time [ms] - - 3 4 5 6 7 8 9 10
LEFT DECK HOT CUE 1 HOT CUE 2 HOT CUE 3 HOT CUE 4 LOOP IN LOOP OUT AUTO FX1-1 FX1-2
FX1-3
Interval time [ms] 11 12 13 14 15 16 17 18 19 20
RIGHT DECK HOT CUE 1 HOT CUE 2 HOT CUE 3 HOT CUE 4 LOOP IN LOOP OUT AUTO FX2-1 FX2-2
FX2-3
Example
:
13ms
LEFT DECK : HOT CUE1-4, LOOP IN, LOOP OUT, AUTO, FX1-1 ~ FX1~3
RIGHT DECK : HOT CUE1-3
13 places of LED turns on.
Press [SHIFT] to return to Normal Mode.
8 9 10
5 6
3 4
7
18 19 20
15 16
12 13 14
17
11
3 ~ 10ms 11~20ms

Denon MC2000 Specifications

General

Brand	Denon
Model	MC2000
Type	DJ Controller
Channels	2
Crossfader	Yes
Software	Serato DJ Intro
MIDI	Yes
Inputs	1/4"
Outputs	RCA, 1/4"
Audio Interface	Yes
Software Compatibility	Serato DJ, Virtual DJ