23
WHEN THE MICROPROCESSOR IS REPLACED WITH A NEW ONE
When the U-PRO (Microprocessor) or the Flash ROM is replaced, conrm the following.
PWB Name Ref. No. Description
After
replaced
Remark
CONTROL
IC400 STM8S207M8T6 B 704-MC2000-A349
After replacing
A
: Mask ROM (With software). No need for write-in of software to the microprocessor.
B
: Flash ROM (With software). Usually, no need for write-in of software. But, when the software was updated, you should
write the new software on the microprocessor or ash ROM. Please check the software version.
C
: Empty Flash ROM (Without software). You should write the software on the microprocessor or ash ROM.
Refer to "Update procedure" or "writing procedure", when you write the software.
PROCEDURE
FOR UPGRADING THE VERSION OF THE FIRMWARE
1. preparation
(1) Connect the computer by USB cable.
MC2000 : Type B
(2) UPDATER
Dowload Dennon SDI site.
for Windows : DDJUpdater-2.0.msi
for Mac : DDJ Updater.app
(3) Latest Firmware
Dowload Dennon SDI site.
le : MC2000_vX.XXX.bin
(XXXX : Ver. No.)
2.InstallingthermwareupdateprogramforWindows
b
Upgrade program for Macintosh is installed on your Mac by copied the DDJ Updater.app.
(1) Double click the DDJUpdater-2.0.msi
MC3000
To Next Page
Loading...
Need help?
General
