25. AUTO. Use this button to enable/disable
a Loop of a pre-selected length in beats.
The LED of this button will blink if a Loop
is enabled.
Hold SHIFT down and then use this
button to enable/disable a Loop of 4
beats length
26. HALF. Use this button to half the size in
beats of the pre-selected Auto-Loop
Hold SHIFT down and then use this button to set a Loop In (Entry) point for manual
looping.
While a Loop is triggered, hold SHIFT down and then use this button to set the jogwheel
to Loop-In mode (led will blink) and fine adjust the Loop-In point using the jogwheel.
27. DOUBLE. Use this button to double the size in beats of the pre-selected Auto-Loop
Hold SHIFT down and then use this button to set a Loop Out (Exit) point for manual
looping.
While a Loop is triggered, hold SHIFT down and then use this button to set the jogwheel
to Loop-Out mode (led will blink) and fine adjust the Loop-Out point using the jogwheel.
28. RELOOP. Use this button to trigger the last triggered Loop (Reloop)
Hold SHIFT down and then use this button to enable/disable the Loop Roll mode (led will
blink when enabled). When the Loop Roll mode is enabled the Loops will act temporary
and when exit, the track will continue playing from the position it would have been if the
Loop was never triggered.
Effects
Both Effect units (on the left and right side) offer 2 different modes and controls for the
Effects applied on the corresponding deck.
Hold SHIFT down and then press the TAP (32) button to toggle between the Single FX and
Multi FX effects mode. The LED of the TAP button will be turned on blue if the Multi-FX
mode is selected.
The Single FX mode offers a single Effect slot with up to 6 Effect parameters and 2 Effect
Buttons.
The Multi FX mode offers 3 Effect slots with up to 2 Effect Parameters per slot.
29. FX1 ON
Single FX Mode. Press this button to trigger the selected Effect. Hold SHIFT down
and then press this button to open/close the FX GUI of the selected Effect.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
