PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC
The procedure after replacing the u-COM (Microprocessor), ash ROM, etc. is as follows.
PWB Name Ref. No. Description
After
replaced
Remark
MAIN IC214 STM32F103ZG
B
SOFTWARE: SYSTEM
MAIN IC206 EPCQ16SI8N
s
A
SOFTWARE: FPGA
MAIN IC102 MX25L4006EM2I
B
SOFTWARE: DSP
After replacing
A
: The software has been written. The software is not written at the time of replacement.
B
: The software has been written. The software may need to be rewritten by version updates. Check the version.
C
: The software has not been written. The software needs to be written after replacement. See “Firmware
UpdateProcedure” for information on writing the software.
D
: The software has been written. Be sure to rewrite with the latest software for your service region. See “Firmware Update
Procedure” for information on writing the software.
25
To Next Page
Loading...
