EasyManua.ls Logo

Derby cycle Impulse 2.0 pedelec - 6.9.5 Storage; 6.9.6 Cleaning

Derby cycle Impulse 2.0 pedelec
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Original User Guide | Impulse 2.0 Pedelec Version 3 EN-59
CAUTION
Cover helical springs. If there are coil springs underneath your saddle,
cover them up. A child being carried on the rear carrier can trap their
ngersinthem.
6.9.5 Storage
1. Remove the battery from the pedelec.
2. Store the battery in a dry, not excessively warm room. The battery
should not be exposed to direct sunshine. The recommended storage
temperature range is 0 to 20°C.
6.9.6 Cleaning
WARNING
Remove the battery before cleaning the pedelec. Accidental activation
of the
button may lead to severe injuries.
IMPORTANT
Do not clean the pedelec and its components with a water hose or high
pressure washer. Althoughthecomponentsaresealedo,damage
may still result. Clean the bike with a soft damp cloth.
Do not immerse the drive unit or components into water. Although the
componentsaresealedo,damagemaystillresult.
Do not use any cleaners which contain alcohol or solvent, or which
scour. No coarse sponges or brushes may be used either. They leave
scratches and cause the surface to become matt. Clean the bike with a
soft damp cloth.
Do not allow dirt to dry out. It is best to clean the cycle
immediately after your ride.

Table of Contents