Derby cycle Impulse 2.0 pedelec - Lighting

Original User Guide | Impulse 2.0 Pedelec Version 3 EN-9
Type Number Position Characteristics
Rear light 1 Rear Red light
The lowest point of the illuminating surface
must not be lower than 250 mm above the
road surface.
A standlight function is also permitted.
Reector At least
1
Rear Red
The highest point of the illuminating
surface must not be higher than 600 mm
above the road surface.
Largereector 1 Rear Red
ThelargereectorismarkedwithaZ.
It can be integrated in the rear light.
Reector 2 per
pedal
Pedals Yellow
Eectiveforwardsandbackwards.
Reector(or
reectivewheel
stripes)
At least
2
Per wheel Yellow
Attachedtothespokesat180˚toeach
other.
Eectivesidewayson.
Reective
stripes (or wheel
reectors)
1 Per wheel Circularcontinuous,reectivewhitestripe.
DANGER
Before you use a trailer bike or trailer make sure you read Chapter
 6.9.2 Trailer bikes and trailers P. EN-56. Otherwise there is a risk of
serious injury or death.
» The attachment of child seats is generally permitted.
DANGER
Before you attach a child seat make sure you read Chapter
 6.9.4 Child seats P. EN-58. Otherwise there is a risk of falling off,
serious injury or death.
V.II.I Lighting
In Germany the requirements for lighting on bicycles is regulated in
Section67oftheRoadTracLicensingRegulation(StVZO)andinthe
Technical Requirements for vehicle parts. Lighting includes both battery
anddynamo-poweredlights,andincludesreectorsthatworkwithouta
powersupplyandsimplyreectexternallight.
Type Number Position Characteristics
Front light 1 Front White light
The illuminance must be at least 10 lux at
the centre of the beam at a distance of 10
metres.
Reector At least
1
Front White
Thereectorcanbeintegratedintothe
front light.