Derby cycle Impulse 2.0 pedelec - 8.3.1.5 Charging the down tube battery with charger type 4; 8.3.1.6 Battery display during charging

EN-78 Original User Guide | Impulse 2.0 Pedelec Version 3
8.3.1.5 Charging the down tube battery with charger type 4
1. Connect the power cable to the battery charger.
2. Remove the protective cap on the battery.
3. Connect the charging cable to the battery charging socket until it engages.
4. Insertthemainsplugintoapowersocket.TheredLEDbrieylightsup
, then the
greenLEDashessteadily
.
5. Thechargerswitchesooncethebatteryisfullycharged.ThegreenLEDis
permanently on
.
6. Remove the power cable from the socket after completing the charging process.
7. Remove the charging cable from the battery charging socket.
8. Replace the protective cap on battery charging socket.
8.3.1.6 Battery display during charging
Display Description Battery charge level

5LEDslightupandnoLEDashes 100 – 97%


4LEDslightupandthe5thLEDashes 80 – 96%


3LEDslightupandthe4thLEDashes 60 – 79%


2LEDslightupandthe3rdLEDashes 40 – 59%


1LEDlightsupandthe2ndLEDashes 20 – 39%

1LEDashes 0 – 19%