Model IR-700
IR-700 Instruction Manual Rev. 4.3 Page 43 of 46
9.2 Spare Parts, Sensor Accessories, Calibration Equipment
Part Number Spare Parts
IR-700 Intelligent Transmitter Module (ITM)
IR-700 ITM with Lower Housing, Cell, and Splash Guard
IR-700 Bottom Housing Assembly (includes Flame Arrestor)
Replacement Plug-in IR Combustible Gas Sensor
Replacement Plug-in CO
2
Sensor (Ranges ≤ 5%)
Replacement Plug-in CO
2
Sensor (Ranges ≥10%)
Sensor Accessories
NEMA 7 Aluminum Enclosure less cover – 3 port
NEMA 7 Aluminum Enclosure Cover (Blank)
NEMA 7 316SS Enclosure less cover – 3 port
NEMA 7 316SS Enclosure Cover (Blank)
Sensor Splashguard with integral Cal-Port
(Included for use in Performance Certificate)
Remote Calibration Adapter
(Not Included for use in Performance Certificate – Will reduce the
response time of the unit particularly on Heavy Hydrocarbon gases)
Harsh Environment Sensor guard
(Not Included for use in Performance Certificate – Will reduce the
response time of the unit particularly on Heavy Hydrocarbon gases)
Condensation prevention packet (for J-Box replace annually)
Calibration Accessories
Threaded Calibration Adapter
Span Gas Kit: Includes calibration adapter, In-Line Humidifying
Tube, 200 cc/min fixed-flow regulator, and carrying case.
Span Gas cylinder: 50% LEL Methane balance air
Contains 104 liters of gas and is good for 175 calibrations
Span Gas cylinder: 25% LEL Methane balance air
Contains 104 liters of gas and is good for 175 calibrations
Span Gas Cylinder with CO2 balance air. (XXX denotes % by
volume concentration i.e. 10% = “-010”)
200 cc/min Fixed Flow Regulator for span gas bottle
Recommend Spare Parts for 2 Years
IR-700 Intelligent Transmitter Module (ITM)
IR-700 Bottom Housing Assembly (includes Flame Arrestor)
Replacement Plug-in IR Combustible Gas Sensor
Replacement Plug-in CO
2
Sensor (Ranges ≤ 5%)
Replacement Plug-in CO
2
Sensor (Ranges ≥10%)
Condensation prevention packet (for J-Box replace annually)
1
Contact Detcon Customer Service for a complete part number