Detcon IR-700 - 10 Revision Log; Model IR

Model IR-700
IR-700 Instruction Manual Rev. 4.3 Page 44 of 46
10. Revision Log
Revision
Date
Changes made
Approval
2.1
12/08/10
Changed ATEX certification line under Electrical Classification in
Section 9.1 from “Eex d IIB+H
2
T4” to “II 2 G Ex d IIB+H2 T4”
to match ATEX approval label for IR-700. Added Revision Log
Section 10.
B.M.
2.2
04/25/11
Removed Teflon note in Section 2.5.
LU
2.3
07/11/11
Added aluminum condulet wiring and dimensional drawing.
Inrush current information added to specifications.
Electrical connections changed from six to five wires.
LU
2.4
04/16/12
Changed cable recommendation, updated the Modbus Register
Map.
LU
2.5
01/08/13
Updated ATEX approvals label, updated EN standards that sensor
assembly meets. Updated ATEX listing in specifications
BM
2.6
04/02/13
Updated ATEX installation instructions regarding use of ring
terminal for earth ground using screw and lock-washer. Updated
guidelines for metric special fasteners used in 700 assembly
BM
2.7
04/05/13
Added 50% LEL Range
LU
2.8
10/17/13
Updated for 4-20mA errors
LU
2.9
11/20/2013
Update Field Wiring
LU
3.0
12/25/13
Update Calibration to include Wind Guard
BM
3.1
02/14/14
Update 4-20mA wiring, and specifications
BM
3.2
09/03/15
Updated accuracy spec, added repeatability spec
LU
4.0
6/16/16
Update cert specs, update technical information
MM
4.1
03/31/17
Change Ag and Rg Values, update P/N for Bottom Housing
BM
4.2
04/17/18
Updates to meet ANSI/UL 12.13.01:2013 Performance Testing
BM
4.3
06/05/18
Updated Conduit Seal in Section 2.5
MM