DETEWE opencom 100 - Using the OpenPhone IPC with an Interface; Program Start

15
Forwarding Calls
Instant (for one MSN)
On:
H*213*
Z
(MSN) *Z (destination no.)
#
Off:
H#213*
Z
(MSN) #
Instant (for several MSNs)
On:
H*213*
Z
(MSN 1) *Z (MSN 2) *
Z
(destination no.) #
Off:H#213*
Z
(MSN 1) *Z (MSN 2) #
An external call for an MSN config-
ured in the OpenCom 100 is for-
warded instantly to the specified ex-
ternal destination and not signalled
on the original terminal. If “Instant
MSN Call Forwarding” is activated on
your telephone, you will hear a spe-
cial dial tone when you pick up the
handset.
On busy (for one MSN)
On:
H*673*
Z
(MSN)*Z (destination no.) #
Off:
H#673*
Z
(MSN) #
On busy (for several MSNs)
On:
H*673*
Z
(MSN 1) *Z (MSN 2) *
Z
(destination no.) #
Off:H#673*
Z
(MSN 1) *Z (MSN 2) #
When a terminal is busy, an external
call for an MSN configured in the
OpenCom 100 is forwarded in-
stantly to the specified external
destination.
After delay (for one MSN)
On:
H*613*
Z
(MSN) *Z(destination no.)
#
Off:
H#613*
Z
(MSN) #
After delay (for several MSNs)
On:
H*613*
Z
(MSN 1) *Z (MSN 2) *
Z
(destination no.) #
Off:H#613*
Z
(MSN 1) *Z (MSN 2) #
An external call for an MSN config-
ured in the OpenCom 100 is sig-
nalled on the destination terminal
and forwarded to the specified ex-
ternal destination after the specified
time set in the OpenCom 100.
All Call Forwarding Off
H#2#
If you have programmed several in-
stances of call forwarding, you can
deactivate them all simultaneously
with the above procedure.
Follow Me
You can activate and deactivate in-
stant internal call forwarding for
your own telephone from any other
telephone, providing you have the
terminal PIN for your own telephone