18
Special Calls
Door Opener
H*11
For consultation calls:
GR*11
If an automatic door opener is con-
nected, you can use this procedure
to activate it from your telephone.
Entrance Intercom Calls
Calling the entrance station
H*101
For consultation calls:
GR*101
If an entrance intercom is connected
to your system, you can use this pro-
cedure to speak with a visitor.
Forwarding entrance intercom
calls
On:
H*151
(for doorbell 1) *(external access
code, e.g.
0) Z (destination tel.
no.)
#
Off: H#151#
You can use this procedure to for-
ward calls signalled by the doorbell
to another (internal or external) tele-
phone number.
Up to three doorbells can be config-
ured in the OpenCom 130. Select the
code
151 to divert calls for
doorbell 1,
152 for doorbell 2
and
153 for doorbell 3.
All entrance intercom calls are termi-
nated automatically after a certain
length of time has elapsed (the de-
fault settings is 60 seconds). This en-
sures that the forwarding of en-
trance intercom calls does not
unintentionally result in a perma-
nent connection (e.g. to a mailbox).
The length of time can be set by your
system administrator to a value be-
tween 30 and 300 seconds in the
OpenCom 100. Please ask him for
the current value.
Keypad Dialling
H*12
Z
(keypad code digits)
For consultation calls:
GR*12
Z
(keypad code digits)
Certain European network operators
require the keypad protocol to be
used in order for you to be able to
set certain features (this is not the
case in Germany).
You use the sequence
*12 to
switch to the keypad protocol, and
subsequently enter the code digits
required by your network operator.
These are transmitted directly to the
exchange and evaluated there.
You will then generally hear an an-
nouncement as confirmation.
To Next Page
Loading...
