Website: www.devicewell.com Email: support@devicewell.cn 17
Transition rate adjustment
When operating the transition effect control area, you can also control the transition rate by
operating the RATE1, RATE2, and RATE3 in the keypad (rate1: 640ms; rate2: 1280ms; rate3:
2560ms) Note: Only when using AUTO transition effective.
6.1.2.4 Integrated control area
PIP picture-in-picture special effects
PIP special effects: Press on the control panel (the green light is displayed after
pressing), and then click AUTO or CUT to switch. The effect is shown below.
Wipe the transition effect to the right, the A picture is unchanged,
and the B picture is gradually drawn in to the right until the picture
becomes B completely.
To Next Page
Loading...
