2
MG6-OLVERT-3B Rev. 0 12/30/99
SAFETY GUIDELINES -DEFINITIONS ........... 1
GENERAL INFORMATION .............................. 2
ON-RECEIPT INSPECTION ............................ 2
WARRANTY STATEMENT .............................. 3
IMPORTANT SAFETY INSTRUCTIONS ........ 4-6
SPECIFICATIONS ............................................ 7
GLOSSARY ....................................................... 7
DUTY CYCLE ................................................... 7
INSTALLATION ................................................ 7-10
Location of Air Compressor ............................ 7-8
Air Compressor Anchoring Methods .............. 8
Wiring Instructions and Diagram .................... 8
Voltage and Circuit Protection ........................ 9
Grounding Instructions ................................... 9
Lubrication and Oil ......................................... 9
Additional Regulators & Controls ................... 9
Piping Instructions .......................................... 10
DESCRIPTION OF OPERATION .................... 11
BREAK-IN PROCEDURES .............................. 12
OPERATING PROCEDURES .......................... 12
TABLE OF CONTENTS
NOTE: Photographs and line drawings used in this manual are for reference only and do not
represent a specific model.
You have purchased a complete compressor outfit consisting of
an air compressor, air tank, electric motor, and associated
controls and instruments. The outfit you have selected is a
stationary model and contains a two stage air compressor pump.
Your new compressor outfit can be used for operating paint
sprayers, air tools, grease guns, air brushes, caulking guns,
sandblasters, inflating tires, etc.
A regularly scheduled program of preventive maintenance will
help provide the long life that has been designed into your
compressor outfit. Before operating or performing any
maintenance on your compressor, refer to this manual and your
Outfit Parts Manual. To keep your compressor in good working
order, refer to these publications often and perform preventive
maintenance steps as recommended.
GENERAL INFORMATION
Each air compressor outfit is carefully checked before shipment.
With improper handling, damage may result in transit and cause
problems in compressor operation.
Immediately upon arrival, check equipment for both concealed
and visible damages to avoid expenses being incurred to correct
such problems. This should be done regardless of any visible
signs of damage to the shipping container.
Report any damages to carrier and arrange for inspection of
goods immediately.
For the location or a listing of the nearest DeVilbiss Air Power
Authorized Warranty Service Center, call our toll free number at
1-800-888-2468, Ext. 2.
ON-RECEIPT Inspection
MAINTENANCE ............................................... 13
SERVICE INSTRUCTIONS ............................. 14-16
Air Filter-Inspection and Replacement .......... 14
Oil-Checking and Changing ........................... 14
Viscosity Chart ............................................... 14
Oil Type .......................................................... 14
Oil Levels ........................................................ 14
Check Valve-Inspection and Replacement ... 14
Safety Valve-Inspection and Replacement ... 15
Belt-Replacement........................................... 15
Adjusting Belt Tension.................................... 15
Motor Pulley and Flywheel Alignment ............ 15
Motor Overload Protector-Reset .................... 16
Motor Lubrication ............................................ 16
Compressor Head Bolts-Torquing ................. 16
Additional Service ........................................... 16
STORAGE.......................................................... 16
TROUBLESHOOTING GUIDE ........................ 17-20
ACCESSORIES ........................................ Back Cover
To Next Page
Loading...
