12- ENG
D26805
INSTALLATION
Location of the Air Compressor
Exhaust from the gasoline engine contains deadly carbon
monoxide, which is odorless and toxic. Operate engine
only in well ventilated areas.
The air compressor must be operated in a clean, dry, and well-ventilated area.
The air compressor's crankcase and head are designed with cooling fins to
provide proper cooling. The fan blades of the compressor, the flywheel, must be
kept clear of obstructions that could interfere with the flow of air through the air
intake filter.
Do not install the air compressor in a location where heat is excessive. If
the humidity in the operating area is high, an air filter can be installed on the air
outlet adapter to remove excessive moisture. This type air filter is not provided
with this air compressor and must be purchased separately. Closely follow the
instructions packaged with the filter for proper installation.
Do not allow the air compressor to get wet if it is installed
outdoors.
Piping
Plastic or PVC pipe is not designed for use with
compressed air. Regardless of its indicated pressure
rating, plastic pipe can burst from air pressure. use only metal pipe for air
distribution.
If a pipe line is necessary, use pipe that is the same size as the air tank outlet.
Piping that is too small will restrict the flow of air. If piping is over 100 feet long,
use the next larger size. Bury underground lines below the frost line and avoid
pockets where condensation can gather and freeze. Apply pressure to lines
before underground lines are buried to make sure all pipe joints are free of leaks.
Air Compressor
The air compressor pump was filled WITH oil at the manufacturer. Check air
compressor pump oil level before operating unit. If necessary, fill pump to the
appropriate level with approved compressor oil, see the Maintenance section of
this manual for details.
To Next Page
Loading...
