22 Initial use
devolo dLAN pro 1200+ WiFi ac
쎲 Two Ethernet ports
쎲 One reset button
쎲 Four internal Wi-Fi antennas and
쎲 One integrated electrical socket
3.3.1 Encryption button
This button controls the following functions:
Encrypting the dLAN pro network
쎲 To encrypt your dLAN pro network individually,
press each encryption button on the connected
devices for approximately 1 second—within 2
minutes.
쎲 To remove a dLAN pro device from your network,
press the encryption button on the correspond-
ing device for at least 10 seconds.
For more information about this, refer to
Chapters 3.4 Connecting the
dLAN pro 1200+ WiFi ac or 3.6 Remove
dLAN pro 1200+ WiFi ac from the dLAN
pro network.
Indicator lights
The integrated indicator lights (LEDs) show the dLAN
status for the dLAN pro 1200+ WiFi ac by illuminating
and/or flashing:
쎲 The LED flashes red quickly at regular intervals
if the dLAN pro 1200+ WiFi ac is connected to the
mains supply but there is no dLAN connec-
tion.
Check whether the device is connected to the
mains supply correctly and whether the encryp-
tion process has been carried out successfully.
For more information about this, refer to 3.4
Connecting the dLAN pro 1200+ WiFi ac.
쎲 The LED lights up white if the
dLAN pro 1200+ WiFi ac is ready to operate
and a dLAN connection exists.
Fig. 5 is country-specific